any ruger
Blackhawk
Does anybody know the size of the allen screw that holds the shell holder in place?
Spar t
- Thread starter any ruger
- Start date
Help Support Ruger Forum:
recumbent
Buckeye
10-32 x 1/8"
I have a parts list for the press in a pdf file.
PM me your email address and I'll send it to you.
Bob
I have a parts list for the press in a pdf file.
PM me your email address and I'll send it to you.
Bob
Enigma
Hunter
Anyone know where to score a primer catcher for one? I think they're made of unobtanium! A good project for someone with a 3-D printer.
Tom-R2
Bearcat
Enigma said:
I took an old Speer plastic bullet box, drilled a hole in it big enough to put the ramrod through it and a couple of holes for the primers to drop out the bottom into the trash. You would have to be sure to place the hole close to one of the long sides so that it will not bind between the ram and the frame. I couldn't find one when I searched for one. I did buy one the some guy created with a 3D printer, but it didn't seem to work sell. Mine is a little unorthodox but it was something I had on hand. Looks ugly, but it works.
