ltapd204
Single-Sixer
I acquired an old model Single Six some time back that only had the magnum cylinder. I was lucky enough that a fellow forum member had an old model 22LR cylinder with the correct OAL. The cylinder arrived and looked brand new and the fit is perfect. The only problem is that 4 of the 6 chambers are very sticky or tight. I can't hardly get the rounds to chamber in these 4 and when I do then extraction is very difficult after shooting. Looking in the cylinder bores I don't see anything that would cause this. I have tried to use a 22 caliber bore mop with flitz and a drill to polish the chambers, but this has not corrected the problem.
Does anyone have any suggestions? Thanks.
Does anyone have any suggestions? Thanks.