rjunkin
Bearcat
Has anyone experienced an SR9 or SR9C that has a manual safety that won't fully engage? I noticed it was sluggish at the shop before I bought it but attributed that to the grease that the gun was shipped in. Unfortunately after a thorough cleaning the safety now will not engage fully, and a pull or two on the trigger will cause it to completely disengage (just like it says in the manual).
I found that if I push the slide back about 1mm, the safety lever will move full up, but when I release the pressure on the slide the safety level drops enough to allow the trigger to disengage it. I'm sure its just an adjustment, but I'd like to know if I can do it myself or not.
Thanks in advance for your help!
Cheers,
Rick
I found that if I push the slide back about 1mm, the safety lever will move full up, but when I release the pressure on the slide the safety level drops enough to allow the trigger to disengage it. I'm sure its just an adjustment, but I'd like to know if I can do it myself or not.
Thanks in advance for your help!
Cheers,
Rick