SavageDetroit
Bearcat
So I picked up my first handgun this week from a member here on the forum, a new SR9c Stainless.
I have not shot it, maybe tomorrow, but I have shot the full size before.
I've taken it apart, removed the mag disconnect, cleaned it, etc.
I was over at Impact Action today and I overheard one of the employees talking up the Blackhawk SERPA Holster.
It is the one that has the lock that you release with your trigger finger as you withdraw.
So I bought it, well actually the one for the full size SR9, and I was pretty happy with it until I turned the pistol over and notice wear on the trigger guard. The trigger guard area is dulled compare to the rest of the grip frame. I only pulled the pistol in and out a few times. I tend to be anal about things like this. Should this be expected and I making too big of an issue of this? If I am not, is there any way to restore the affect area?
I have not shot it, maybe tomorrow, but I have shot the full size before.
I've taken it apart, removed the mag disconnect, cleaned it, etc.
I was over at Impact Action today and I overheard one of the employees talking up the Blackhawk SERPA Holster.
It is the one that has the lock that you release with your trigger finger as you withdraw.
So I bought it, well actually the one for the full size SR9, and I was pretty happy with it until I turned the pistol over and notice wear on the trigger guard. The trigger guard area is dulled compare to the rest of the grip frame. I only pulled the pistol in and out a few times. I tend to be anal about things like this. Should this be expected and I making too big of an issue of this? If I am not, is there any way to restore the affect area?