SP 101 Ejector Alignment Pin

[Pete]

I have an SP 101 .357 that is missing one ejector alignment pin.Is there a drill bit gauge that is the same diameter as the Ruger pin?If not what diameter is the pin?

 

[Carry_Up]

The pin underneath the cylinder ratchet? Are you saying you now have a hole where the pin used to be?

-CU

 

[Pete]

Yes,that is correct!

 

[Carry_Up]

Never heard of the pins dropping out. Mine measures .062" which would be a 1/16" drill bit. Cut it, round the top and tap it in with red loc-tite.

 

[Pete]

Thank you very much!I finally managed to measure the remaining pin and just a few hours ago replaced the missing pin.
I had not heard of a pin coming out either but when it comes to a revolver I get to repair all sorts of things!