shoot to thrill
Single-Sixer
Took apart my M-77 ruger tang safety put it back together and when I retract the bolt a lug on the bottom pushes the safety back. If I put the safety off with the bolt back it will not get past the safety unless I push it forward up the ramp then it barely clears it.
the tang is in the recess all the way even a little below the wood. tang screw is tight and sticking up a little into the groove for the bolt.
took it apart 10 times using different tightening sequences. still exactly the same. naturally it did not hit the safety until I took it apart. What did I do wrong?
the tang is in the recess all the way even a little below the wood. tang screw is tight and sticking up a little into the groove for the bolt.
took it apart 10 times using different tightening sequences. still exactly the same. naturally it did not hit the safety until I took it apart. What did I do wrong?