tek4260
Buckeye
Length marked, sight hole marked.
Drilled. Ready to tap.
And there were 2 front sights
After the hacksaw attack
Crowned
Dirty ol revolver
New trigger spring from an expensive ball point pen. Simply cut to length and crimp one end down slightly so it will grab the recess in the plunger as the factory did. About half the diameter of wire and a lot lighter trigger is the result
26# progressive mainspring as compared to the shorter smaller factory spring
And here is how you prepare a .595 Blackhawk sight for screw attachment
Scribe prick at center according to my caliper.
Started with center bit
9/64" hole through the sight. Now to countersink for screw head.
7/32" countersink
Torx head screw as it will be when on the revolver.
Under the sight, I roughed up the barrel and the bottom of the sight with a file, cleaned it with acetone, then applied real JB Weld. I cleaned off the excess with a razor knife before it cured.