I have a pre-warning NM 357 Blackhawk which is remarkably accurate and trouble free. However, recently it's been hanging up on cocking; the transfer bar is hitting the bottom shoulder of the firing pin and preventing full cock. It appears as though the base pin has just a bit too much fore and aft play to where the spring-loaded pin at the end of the base pin isn't always do its job of pushing the transfer bar towards the rear.
What is the recommendeed cure for this situation? It seems to me a slightly oversize base pin latch would resolve it, but I don't know where to get one or if they're offered. I'd appreciate some professional advice.
Many thanks!
Acebrace
What is the recommendeed cure for this situation? It seems to me a slightly oversize base pin latch would resolve it, but I don't know where to get one or if they're offered. I'd appreciate some professional advice.
Many thanks!
Acebrace