Need advice on Ruger P series work

[gander]

I'm ordering a Wolff spring kit (265760) for my P95 and P345. Have any of you guys switched to a lighter hammer spring in these models? If so, what spring strength did you end up with on your pistols? Any downside to lightening up on the hammer springs?

Also, I would like to buff my P345 sear and hammer using my Dremel. Could you recommed a good buffing compound that would not remove much metal, but still give me a smooth finish? I have one little gritty spot at the start of the single action trigger pull that I'm having trouble eliminating.

Thanks for the replies.

 

[BuckJM53]

Gander ... The only down side that I'm aware of in going with the lighter hammer spring on the P series pistols is the potential for light primer hits. With the stock spring being 23 lbs., I decided to go with a 21 lb in both my P95 and P345. While the difference was most noticable in DA, it did make the SA pull a bit nicer as well (a friend of mine tried the 19 lb spring and did end up having an issue with some light primer hits). Good luck with the modification!

 

[Mike J]

Wolff sells a kit with 19,20 & 21 pound springs included. I had the 19 in my P-944 for a couple of years. I changed it back because I decided I didn't like how it felt anymore. It is still nice now-I think after a couple thousand rounds fired & a bunch of dry fires the parts smoothed themselves out resulting in a smoother pull.