Jhuppdog
Bearcat
Well after 650 rounds I thought it was time to tear down the gun and give it a good cleaning. I watched the videos and read the procedures and everything was pretty straight forward. My issue is the removing of the receiver from the frame and then then putting the two back together. I know that it says it MAY be necessary to give the back of the receiver a small strike with a plastic hammer, but it took me multiple strike with a large rubber mallet to get my receiver and frame to come apart. It took 5+ strikes to get the receiver to go on to the gun and seat properly on the frame. After my first attempt to assemble the two, I removed the receiver and looked at the lug that goes into the the bottom of the receiver. The lug on the frame is flat on top and shaped like a half moon on the bottom. The hole on the bottom of the receiver for this lug to go into does not look like this. The shape is different. I wish I would have taken a picture but instead went forward with the re-assembly. After the second try and quite a few strike with the mallet and the gun was assembled. Everything works fine I am just concerned with the amount of force it takes to free the two and why the lug and the hole for the lug to not match in shape. Is this amount of force usual or do I have an issue?
Thanks,
Jeremy
Thanks,
Jeremy