Feb 16, 2022 #1 T twister2k33 Bearcat Joined Feb 16, 2022 Messages 3 I need to deep clean my LCR 357 mag. Can someone tell me what size hex wrench I need to remove the cylinder? I can't find this info anywhere online.
I need to deep clean my LCR 357 mag. Can someone tell me what size hex wrench I need to remove the cylinder? I can't find this info anywhere online.
Feb 16, 2022 #2 hittman Moderator Staff member Moderator Joined Jan 16, 2008 Messages 17,203 Location Illinois Welcome to the forum. No idea what tool you need. I've never had one dirty enough to require disassembly. Just spray it out with CLP or other cleaner/lube, run Hoppe's soaked patches thru the chambers and bore and you're probably good to go.
Welcome to the forum. No idea what tool you need. I've never had one dirty enough to require disassembly. Just spray it out with CLP or other cleaner/lube, run Hoppe's soaked patches thru the chambers and bore and you're probably good to go.
Feb 16, 2022 #3 T twister2k33 Bearcat Joined Feb 16, 2022 Messages 3 it's a hex nut I think...but oddly I can't find this info anywhere online.
Feb 16, 2022 #4 hittman Moderator Staff member Moderator Joined Jan 16, 2008 Messages 17,203 Location Illinois Your owners manual have a schematic? Maybe Ruger's web site has a video.
Feb 16, 2022 #5 Captain America Hunter Supporting Member Joined Dec 17, 2015 Messages 2,378 Location Reading, Pa My .38 LCR uses a T10 Torx.
Feb 16, 2022 #6 T twister2k33 Bearcat Joined Feb 16, 2022 Messages 3 thanks captain I'm sure it's the same size on the 357