I am trying to replace the factory front sight with a Millet.When I push in the plunger and try to pull it out it will not budge.Any tips or advice would be greatly appreciated.
GP100 front sight removal
- Thread starter 264winmag
- Start date
Help Support Ruger Forum:
actionflies
Bearcat
The sight is slotted in at an angle so try to wiggle it while pulling up. Make sure the plunger is press all the way in.
Jimbo357mag
Hawkeye
If I remember right the back(?) of the sight, the part closest to the grip, comes up first. 
...Jimbo
...Jimbo
GP100man
Buckeye
put front site in a padded vise upside down , push plunger , lift rear of revolver , file the square end to fit, I`ve actually had to take a punch & tap 1 out!!!
