3leggeddog
Single-Sixer
Even after 300 rds. the trigger pull was still hard. Just by pure luck, while I had the slide off I took a business card and tried sliding it between the [inside] the frame and the trigger bar. It would just start to go in, but NO further, then I forced the corner in alittle further and removed it.I believe the bar was dragging on the frame= increase trigger pull! So I folded the business card over so its twice as thick and and re forced the corner in and slide it forward some. let it set for 3-4 minutes. I recheck it with a single card which now would go in and slide along most of the trigger bar with out too much drag. Go slow and try to get a little clearance. The trigger pulls SO much smoother and seem like its down to 5 lbs pull now. I hope this helps some else!