Help Support Ruger Forum:
-
-
I took gun to the range yesterday and it shot 6" low at 25 yards with my favorite plinking loads. The only loads it shot close to POA @... -
This is kind of a shout out for Simply Rugged holsters. I have several of his holsters and have never been disappointed. I ordered...
-
In the 70's I had a 6" Sec 6, a 4" & a 2 3/4" Speed 6. All were stainless. Only a few aftermarket grips available for these at the time...
-
Covering a round butt with a rubber bumper is not much different than putting a rubber bumper on a square butt. To each his own...
-
I did the same, (shown with Speed Six grips) and bobbed the hammer, on a Service Six. Handy carry 357.
-
Zeke38 replied to the thread Ruger Security Six - 4" barrel.Enjoy your Six, great revolvers!
-
Won the bid on this Security-Six at auction for $370 last month. After the sales tax and buyer's premium I paid out approximately $420...
-
Zeke38 replied to the thread How many carry a 44 daily?.jEEZ, Have Gun I really wish Taurus would bring that little 441 3" back out. Especially since ammo manufacturers are making some good SD...
-
Zeke38 reacted to Ruger 10/22's post in the thread KSP-321X Ruger SP101 357 Magnum 2 1/4" with
Like.
First off, I will have to just say something I always thought that the MIM Parts made the newer made guns cheaper & easier to assemble &... -
You have a VERY narrow market on those items. I’ve no clue on value though. You’ve got some research time and efforts ahead of you. I’d...
-
Zeke38 reacted to noahmercy's post in the thread What .45 ACP do you conceal carry most often? with Like.
My "winter gun" is a Springfield Champion LW Commander that I've shaved a few ounces off of. Hogue aluminum mainspring housing, replaced...
-
Zeke38 replied to the thread A little bit of chrono data from my 3-inch SP101.Bigfoot google 38-44 loads. Used in N frame Smiths and Colt DA large frame revolvers from the 1930s to the 1960s. Basically a 158 grain...
-
Zeke38 replied to the thread Been gone a while!!.Very Nice Collection
-
Not mine but just thought I would share. Any opinions---good--bad or other wise?
-
I cast my own bullets and have an excellent bullet in the Mihec (MP Molds) 250 gr H.P. When cast of the proper alloy, this bullet...
-
-
Loading…
-
Loading…
