Recent content by Tom K

Help Support Ruger Forum:

  1. Tom K

    Backup iron sights on PC Carbine 9mm

    So I did finally get out to the range with all of the appropriate tools and parts and ammo, and shot comparison targets at 60 yards with both the stock iron sights, and the BUIS that I had been using. Looks like the increased sight radius of the BUIS does make a difference. I'd say they reduce...
  2. 20220823_211547.jpg

    20220823_211547.jpg

  3. 20220823_211511.jpg

    20220823_211511.jpg

  4. 20220823_212048.jpg

    20220823_212048.jpg

  5. Tom K

    Backup iron sights on PC Carbine 9mm

    Last week I tried a few different types of ammo through the PC Carbine. Best results were with some Speer Lawman 115 gr JHP that I've had for years. I shot it at 60 yards again off a bench rest with scope, and the backup iron sights that I put on it. Again I was going to try the gun with the...
  6. 20220815_110835.jpg

    20220815_110835.jpg

  7. 20220815_110858.jpg

    20220815_110858.jpg

  8. 20220815_111016.jpg

    20220815_111016.jpg

  9. Tom K

    Ruger LCRX 327 Long Colt Rounds Questions

    That's SG Ammo, not SAG. Order enough of any kinds of ammo that it totals over $200 (not hard to do these days) and shipping is free. https://www.sgammo.com/
  10. Tom K

    32 Single Six convertible

    You might try Bobby Tyler of Tyler Gun Works. https://www.tylergunworks.com/
  11. Tom K

    Backup iron sights on PC Carbine 9mm

    Not necessarily. It could just be my crappy shooting. Or it may be that this is the best this gun can do with this ammo at this distance. Not quite apples and apples, here is a typical 20-yard group I shot while getting sights adjusted on my newly acquired Rossi lever action. Compare with the...
  12. 20220731_095531.jpg

    20220731_095531.jpg

  13. 20220729_100102.jpg

    20220729_100102.jpg

  14. 20220729_100116.jpg

    20220729_100116.jpg

  15. Tom K

    Backup iron sights on PC Carbine 9mm

    Like some other folks, I would like an option to put a peep on the receiver of the PC Carbine rather than using the factory peep mounted on the barrel. This would nearly double the sight radius between front and rear sight. Unfortunately as far as I can tell, with the factory front sight height...
Top