Recent content by tatwell

I agree about the bit being the best choice. However, if you have a Dremel tool and the Dremel router base-steady hands help too- you can do a nice job. I used this method to install some brass inlays in a ukulele and a guitar I recently built. I do not know what kind of grip material you have...

Thanks again for the information. My gunsmith just let me know that my gun is ready, and I'll be picking it up this morning. "Lost Sheep", thanks for your input. It did look to me like a holster for the Alaskan might work with a cut down redhawk, but now that I know that a S&W N frame holster...

Thanks for the info. I usually make my holsters, but I thought it might be nice to just order one. I would have bought an Alaskan in 454-and shoot 45 Colt, but right now I do not have the funds. Plus I already have the Redhawk, and I found the cost estimate from a local gunsmith to be very...

Hello to all. I'm new here, but have been lurking and reading this forum for a long time. I've spent the last few days reading the posts on cutting down a Redhawk barrel. I finally decided to have it done by a local gunsmith, and it should be ready in a week or so. The finished barrel length...