Recent content by steelheadnw

I had the same problem with my lcr 22, very low and quite left. I sent it in and now it shoots point of aim at 25 yards and is well centered. Good experience with Ruger service. james

Pm sent. James

PM'd again....lol James

PM sent on less wear grip frame. james

CBH, If it is aluminum and not recent production, say the last 6 years or so it is probably anodized. I'll take it, PM me your info and I'll get a postal MO out to you. Thank you! James

Any one? Bueller?

I'm looking for either a NXR3-RED (early transition new model) or an XRN-3RED grip frame in aluminum please. I'd prefer an anodized model. Thanks for scrounging through your parts boxes. James

PM sent on top XR3. james

I will take it if not sold. james

Wow, lots of people looking at this post, but no one has one... Well< I always thought Ruger had restricted gunsmith only parts, they have apparently changed that policy. I ordered two(SBH Hammers) today from a very helpful person in the parts department. james

any one, Bueller?

I'm looking for a Montado or New Model Super Blackhawk Hammer for my Vaquero Sheriff in 44 Spl. Thanks James

I just got mine back from Ruger, here is the thread. I think Ruger may carry different offset front sights, they do have different heights. Might give them a call. 2" off at 20 yards is not too bad.. http://www.rugerforum.com/phpBB/viewtopic.php?t=146716 james

I received the LCR yesterday and took it to the range today. Ruger replaced the barrel and sight. They also sent a target back with it showing a fair group low center on a 7.5 yd target. It now shoots point of Aim with most of the ammo I have on hand. Kudos to Ruger repair this time, much...

Shot it off the bench, off hand... my cop BIL shot it ...all low left, Ruger had it picked up on Tuesday. Hopefully I'll report excellent sight regulation on the next report. james