Help Support Ruger Forum:
S
snakeeyes4445
- Messages
- 118
- Reaction score
- 4
Latest activity Postings About Post areas
-
-
Ssnakeeyes4445 replied to the thread Pawn shop finds yesterday…Updated! Got it!.My blue .44 spl NM ft shoots very close to as small a groups as a custom barreled, line bored Clements Custom 7.5, and the new model...
-
Ssnakeeyes4445 replied to the thread SP101 tooling marks/frame damage.Trigger shims and an action job will make a world of difference in how you feel about your revolver.
-
Ssnakeeyes4445 replied to the thread 41 Magnum Blackhawk.I lucked into a non Premier Six in Freedom arms and put a 2x7 Simmons on it. I scoped my 6.5 three screw .41 with a Leopld 2x8 to work...
-
Ssnakeeyes4445 replied to the thread "Ruger LCR Revolver in 327 Federal Magnum, for Close Quarters Self Defense?".The Critical Defense 32HRM load, I have heard, meets the FBI criteria just fine, so that's what I carry in my LCR. lot of noise there...
-
Ssnakeeyes4445 reacted to NC FNS's post in the thread "Ruger LCR Revolver in 327 Federal Magnum, for Close Quarters Self Defense?" with
Like.
I’m not condoning warning shots, but if you had to, 327 is so dang loud it would do the job… -
Ssnakeeyes4445 replied to the thread Ruger Single Seven 327 Federal Magnum.My 5.5 came from the factory in perfect spec. Two Dogs custom front and a Bowen rear with Powers hammer and trigger gives a two pound...
-
Ssnakeeyes4445 reacted to Bruce51's post in the thread Ruger Single Seven 327 Federal Magnum with Like.
FWIW I will tell the story of my own Ruger Single Seven so this information is available to others considering purchasing this model...
-
Ssnakeeyes4445 replied to the thread Blackhawk OM Flattop Barrel Problem - Need ideas......Seriously, I would chase both male and female threads carefully, then clean, epoxy and reassemble to the index mark. You should always...
-
Ssnakeeyes4445 replied to the thread Blackhawk OM Flattop Barrel Problem - Need ideas......Those threads look like my spark plugs when I try to change my own.
-
Ssnakeeyes4445 reacted to nrobe50's post in the thread Blackhawk OM Flattop Barrel Problem - Need ideas..... with Like.
If it's an aftermarket barrel, Ruger probably would not work on it.
-
Ssnakeeyes4445 replied to the thread New SP101 in .327 arrived today - Quality Control ???.This might be long, but could be of interest on this thread. I have three of these great little revolvers in .327 Fed. I like the...
-
Ssnakeeyes4445 reacted to dickydalton's post in the thread New SP101 in .327 arrived today - Quality Control ??? with Like.
Almost every SP 101 in 327 from back in 2008 has the barrel out of line. It's not a new thing.
-
-
Loading…
-
Loading…
-
Loading…
