Recent content by Pete

WTB a set of the "magna "style grips that are beat up.I plan on using these as an epoxy putty base for some different grips so they can be in BAD shape!!!

I want to buy some of the oversize wood grips for a Security Six serial # 152-xxxxx.A rough set would be OK ,I just want some to put on a shooter.

Thanks !!!!

I was going to try the 14 pound spring but that is good to know about the GP springs!

Thank you! i searched for Wolfe a while back and for some reason was blocked from the site!

Where can I buy some reduced power hammer springs and trigger return springs for this revolver?

You will love Fermin's sight!!!

Please listen to what woodsy says! Stainless steels must be passivated with either nitric or citric acid.If you are going to remove the oxide coating or pitting on stainless it is best to use a pad that is not steel and then apply a little citric acid on the area to keep down further oxidation.

I for one would love to have hondo44 as a neighbor!!!!!

Thank you,I will try that !

Thank you both very much! My revolver does not have a stud and the hole in the housing measures 0.220.

Are there differences in the aluminum ejector rod housings on .357 Blackhawks? I have and old model with a messed up housing and need to know what to look for.

Jim, Thank you very much for the help and information.The suggestions and help I have received from everyone is much appreciated! I calculated the height addition from at the groups I fired at the range and am confident on the increase.I have a sight coming from Two Dogs and hopefully can find...

Thank you all for the help! I should have posted this earlier but both me and my wife have been sick.I got the barrel on and correctly timed,It was a little tight to begin with but finally with a little patience I got it fit to the frame.I have shot it several times since then and the only...

I will take #5 XR3 walnut panels,PM to follow.