Recent content by mikemck

Dang, sorry about that. 4" barrel. Asking $525

Ruger GP-100, 4" bbl, 357 Mag, fiber optic front sight and factory front sight, factory grips and Hogue grip, box, papers. Comes with approx 150 rounds of ammo and 1 safariland speed loader. Excellent condition. SOLD

BTT....

200 rounds of WWB .357 mag 110 gr. JHP, 50 rounds boxes - $16 each or $60 for all 200 rounds. Speer Gold Dot .44 Mag 200 gr GDHP short barrel hollow point, 20 rounds - $18 Speer Gold Dot 44 SPL 200 gr GDHP - $18 Ultramax .44 Russian 200 gr. RNFP, 50 rounds - $22 24 rounds of Federal Hydra...

Oh yes, I've put around 200 rounds through it, mostly with a reflex sight attached. I took the reflex sight off yesterday though, and have not sighted it in with the factory iron sights. I'm not sure who did the work, as I bought it this way. The work was done very well, and the gun is in...

Ruger SBH 44Mag "Bisley"..Barrel has been shortened from the original length of 7.5" to 5" now. Free spin cylinder with a belt mountain base pin. Exhibition grade California Claro Black Walnut Grips. Topstrap has been drilled & tapped for a scope base. Also have A Ruger factory Chest holster...

Still available....

Still available...

PM sent..

I bought this from another forum member, so I'm pretty much just using his original post to describe the Bisley I have for trade. I have $675 in this Bisley: Ruger SBH 44Mag "Bisley"..Barrel has been shortened from the original length of 7.5" to 5" now. Has a shortened weigand D&T scope base...

I'll take it. Thanks BigRyan.

PM sent..

Now that it's been mentioned, the first round I shot didn't even hit paper, from around 25 yards. So, I moved up to around 10, and it landed high, so I adjusted the rear sight, shot it again, and it was pretty much on target. I then moved back to around 25 yards, and it was shooting to point of...

Took my SBH out yesterday, and had several cases that were hard to extract, using WWB. I assumed it was the ammo, so I switched to some Remington I had on hand, and after the sixth shot, I opened the loading gate, and found that the cylinder would not turn. Popped out the cylinder, and found a...

Ah, thank you. Can you tell me which frame model is which? Also, I assume the grips are not interchangeable?