Just picked up a 10-22 rifle with a 24" bull barrel from Gun Parts Corp. Stock with a wide flat fore end.
Serial dates to 1993. Has a metal trigger group that has a really nice trigger pull.
Looking for info on the stock mostly. Only marking I can see is under a Morgan adjustable Butt plate.
Any...
I have the LCR 38 and a Taurus 709 in 9mm for my primary ccw
I personally do not like pocket carry of any of my weapons
I have kydex holsters for my ccw with the J hook style of belt loop
I carry mostly at the appendex location and some carry at the back hip
Much easier for me and much easier to...
"Oh, and the Ruger factory 25 round mags are a hoot. They're a really good way to burn through a brick of ammo quickly! "
really fast if you pick up a shooters ridge loader for it
Mike
I put one on my rifle last week
I can see the iron sites thru the groove with a redot site mounted
It is just visible at the bottom of the groove but it is functional
A solid built mount with 4 screw mounting to the reciever
I like it
Mike
SOLD
Came on a 10/22 I traded for
Old eyes can't use this and replaced with a scope
very good condition, has the gold bead front site
30.00 plus shipping, prefer paypal
can email pics if wanted
Thanks Mike
Savannah, Ga.
JustsaMo, did you change out the sights yourself or have it done?
I am tring to remove the front williams site on my boat paddle 10/22
and it won't budge using a brass drift.
Going to a scope for my old half blind eyes
Want to replace the factory front sight so if needed I can use the factory...
Need some advise on removing and reinstalling a front site
Have a stainless rifle with williams peep site setup
Going to a low power scope and need to remove the front sight as it is taller than the factory site and cannot use the factory rear site with it
Then reinstall factory site
Have tried...
Mine was off just a small amount
Loosen the allen screw on the left side, install the barrel, adjust for
proper alignment, remove barrel and tighten allen screw
reinstall barrel and readjust barrel tension nut, 1.5 minutes
Perfect
Mike