Recent content by Easy Ed

Folder: Sent messages Sorry Scott, Tried to send this Aug 30th but it didn't go. I jumped a little quick on these. I don't know if you've seen my post in Rugersmithing or not but been talking to Hondo about a different hammer for my O/M 30 carbine. The one I have is a good hammer but is...

Scott I didn't get your phone number. Thanks. Ed

Hi Scott. How are you bundling them? I need a large one but may take the bundle. Let me know before you let anymore go. Thanks. Ed

Hello Hondo. Thanks for getting back with me. I appreciate your taking time and posting pictures and all the information. I knew about the grip frame change but didn't know the reason for it. My problem is the hammer was ground to a minimum from the factory. There is only .272 from the round...

Hi Guys. Working on an OM 30 carbine Blackhawk. I've got an OA gripframe about fit to it now. The big problem is on the original hammer, Ruger ground too much off the back letting it sink to deep below the ears on the gripframe. I know there is quite a bit to file down here but when it's...

WTB parts for om Blackhawk. Need a wide trigger. Can be either an original or a conversion trigger. Also need a cylinder latch and a trigger spring and plunger. Thanks for looking. Ed

Thanks for the quick response Jim. I'll post over in the classifieds. Yep, it's got a steel ejector rod housing on it already. Also like to thank you for all the articles and gunsmithing tips you put on here. I read them all. Ed

Getting ready to install an Old Army steel grip frame on an om 30 carbine Blackhawk and I need a wide trigger. Does anyone have one they would turn loose of? Also need an om trigger spring and plunger for an old flat top I'm working on. On a side note. Will a nm cylinder latch fit an old...

I have just finished replacing a firing pin in my old model 30 carbine Blackhawk. This Blackhawk was bought on gunbroker and came with the firing pin broken. This being my first time, I thought I would let those who have never attempted it know what worked for me. First off I read the...

Thanks Eric. Just don't like watching the Hammer fall like slow motion. I like a snappy action. Ed

Thanks Guys. I did a little checking today and found the one Eric mentioned from Brownells. Another one from Numrich. Going to try Ruger again monday with New Model numbers, see how that flys. Flatgate I don't have to find a serial number, I've got plenty of New Models in my collection...

I Just got off the phone with Ruger trying to buy a firing pin for my old model Blackhawk, 30 carbine, serial # 8123. They said no deal, had to be factory installed. I've worked on guns a long time and this is a job I can handle. Is there a person on here that has a firing pin they would...

Sounds good. Please put me in and thanks. Ed

Please put me in and thanks. Ed

Sixshot, Little donation on the way. Ed