Help Support Ruger Forum:
-
-
DDoes anyone know a way to remove the Ruger faux case colored finish they used on Vaqueros? I'm looking for something chemical rather...
-
DSorry I hate to tell you this, but I don't think that is an over stamp. The stamping dies were not square to the frame when it was...
-
DGet an old wire clothes hanger and make one of these. Not my idea. I found it somewhere.
-
DDutchV replied to the thread The process of adding a RW grip frame to a Ruger.If you can make them, I'm sure you could sell a few sets.
-
DDutchV reacted to Randyzzz's post in the thread The process of adding a RW grip frame to a Ruger with
Like.
Well, after as thorough an internet search as I can imagine, they seem to be made of unobtanium. I may have to see about making a set... -
DOften, we as kids just knew what we were getting for Christmas. Especially when it was something we really wanted. But the wait,, the...
-
DDutchV reacted to contender's post in the thread The process of adding a RW grip frame to a Ruger with Like.
I mentioned that I just received a RW grip frame & a set of the 2-dogs/RW rear sights. I wanted to show as best I can, pictures & a...
-
DDutchV replied to the thread Disassembly for hard chrome coating service?.Excellent news! Thank you very much.
-
DDutchV posted the thread Disassembly for hard chrome coating service? in Ruger Single Action & Double Action Revolvers.Has anyone sent a Blackhawk off for hard chrome coating? I'm thinking of Mahovsky's Metalife or a similar service. I know I'd need to...
-
DDutchV replied to the thread Mk II Bull Barrel Receiver Wrench/Holding Fixture.I bet a gunsmith could do the job for less than the cost of the tools.
-
DDutchV replied to the thread Aluminum Alloy Revolver frame.Looks like a sweat stain to me. A coat of oil or paste wax would help protect the finish.
-
DFunny , This Gun was posted here on page 2 post #24 It has been long enough that it has evolved into this now.
-
DDutchV replied to the thread Threading a barrel.My usual guy wants a minimum diameter of .700" for cutting 5/8-24 threads. I'd much rather have the actual thread size than use an adapter.
-
DDutchV replied to the thread NM Bisley Blackhawk FT .44 Special.My mistake. The .44 Specials are pretty rare all by thmselves. Missed that OP was talking about a Bisley.
-
DDutchV replied to the thread NM Bisley Blackhawk FT .44 Special.This one has a Buy Now of $675 - not mine. https://www.gunbroker.com/item/1006570348
-
-
Loading…
-
Loading…