Recent content by c.r.

Bump

Bump

the .44 spcl can be found in a smaller frame revolver.

.475 Linebaugh built by Alan Harton on Blued Ruger Bisley. Later CCH'ed by Bobby Tyler and 5" straight taper rebarrel (not 4-5/8" or 5-1/2"). It has the ejector rod housing from a Maximum, trimmed down to match the barrel length. Bowen Target rear sight. there is a scallop hiding on the...

Perfectly smooth transaction with dwayne. Great communication. Have confidence if you deal with him in the future.

Under contract while we work out the details.

Folks have been kind enough to let me know the pics below were difficult to see. I've attempted to fix this. please use link below for better pics. Thanks. https://photos.app.goo.gl/PktCXW44uG5yJUVp6

thank you.

back at you

updated pics. hopefully better pics. https://photos.app.goo.gl/PktCXW44uG5yJUVp6 • I am the only owner, built sometime between 2007 and 2010 • Began life as a 44 mag SBH, rechambered and rebarreled to 45 Colt • Low round count • Barrel cylinder and end shake set to minimum. Very tight...

Did the post on singleactions state "rechamber" or "convert"? a person could safely convert the medium frame to .44 mag by use of a 5-shot cylinder.

Xtratoy, Brian Pearce listed a 44 spcl load using 300 gr cast bullets. http://www.goodrichfamilyassoc.org/44_Special_Articles/Brian%20Pearce%20on%20the%2044%20Special.pdf I put together a few of these in my FA mdl 97. Shot well, but OAL was a bit too long for me to hunt with. Any bullet creep...

I have a batch of 100 pieces of mixed WW and RP .45 Colt brass with 20+ loads on it. of course not all the loads have been heavy, mostly 255gr bullet at 950 fps, but they have had their share of warm 270 and 310 gr bullets through them at one point earlier in their life. I don't believe i've...

pete, I had a similar issue w/ a freedom arms and a ruger sbh. the fa, I caught early, sent it back, they cleaned up the burs and fitted new hand. the sbh had at 2k+ rounds through it. ruger replaced the cylinder and fit a new hand. in both cases I would have expected the pawl/hand to have...

another bump and link to tips on posting pics http://www.rugerforum.com/phpBB3/viewtopic.php?f=6&t=51390