Recent content by booneh

found it.no mounting screws.mount is new i belive. it's yours if you want it. let me know where to send it. dennis

i will have to look but i think i have an extra.not sure about the screws. if i can find it i will let you know and you can send me your address. dennis

a friend had one for a short time.got rid of it but kept his 338. i think they are limited in bullet weights. booneh

if you drop them they amost allways unload.i belive they were called 6 second loaders. tryed them back in the 70s.they were no faster than hks and not as reliable. booneh

oil of wintergreen works when all else fails. learned this in the navy from an old mechinest mate. booneh

if you use epoxy put as much on as you need to fill the crack heat it up with a hair dryer and use compressed air to blow it down into the crack.the hair dryer will make it very thin so it will flow all the way into the crack. rap it with surgical tubing to close the crack.don't use any more air...

my 2 3/4 inch. security six had a spurless hammer for years.it was not dao.it has a flat on top of the hammer that is checkered.you can pull the hammer back a little and then thumb cock it. if i where buying a new revolver i would buy the spured hammer and bob it and checker the top. just my...

your lucky. if my wife shoots one of my guns[rifle shotgun or revolver] that she likes it is her gun. i have to find her one like it or one she likes better to get mine back. i think this is a good thing. after i get mine back. booneh

it is amazing how fast and how far and how well those things can hide. booneh

if they are clean i would go ahead and load them. after they are clean the shiney is just for looks. hope this helps. booneh

please put my name in. thank you. booneh

check the front tab on the trigger guard. if they are not lined up with the notch in the mag. box and the center screw is tightened they will break. this can let the front of the trigger guard up out of position and it won't stay latched. booneh

4 gr. of red dot and a 158 gr. cast. shoots to point of aim in most fixed sight revolvers. booneh

about any good paste wax will work just fine. make sure you get a good coat or two. booneh