Recent content by BABore

What's the going price for a used Lipsey GP-100, 44 Special, model 1770? Like new condition with a correct height Dawson front sight. Picked one up before the craziness and only have 100 rounds through it. Had my heart set on a S&W 624 Mountain Gun and landed one last winter. Thanks

I looked, 30 seconds! https://www.shootersproshop.com/30-06-springfield-180gr-accubond-trophy-grade-ammunition-blem.html

I bought new Hornady brass when I got my 480 SRH. I got sticky extraction on my initial load workups using WW296. I was at least 2 grains below book max. Solved it by shooting plinker loads for a couple brass cycles. The firing, sizing, and expanding sequence work hardened the brass enough...

Are you using new Hornady brass by chance?

I've been using a MP 359-125 PBHP cast from WW's, sized 0.3574, and coated with Hi-Tek or powder coated. CCI 500's and HS-6 powder. 10-Shot, 50 yard groups run right around an inch. Have a Burris 332 sight mounted. Pull a couple bullets from loaded rounds and make sure your not losing...

Have six of them. They're all I've used in my PC Carbine. No issues. Get one of Magula (sp?) magazine loaders. Makes loading mags fast and easy.

I picked up a Lipsey's 1770 a few weeks ago and began load development. Being a bullet caster, I measured all of the critical features and checked for any barrel constrictions. It was all good with uniform 0.4312 cylinder throats and a 0.004" cylinder gap. I worked up loads with Unique and Power...

New member here, so hello to all. Does anyone know what the diameter and thread pitch is on a 77/357 bbl? Is it the same as the 77/44?