Recent content by AzGeno

Welcome from AZ. S-47s are some of my favorite Rugers. Interested in what you’re looking for.

Working on a new project gun with an interesting history. Any old Colt collectors out there? Looking for an original set of wood grips with medallions to fit a 1957 Colt’s Officers Model D.A .38 revolver. I think this may be a Type 5 model. PM me with what you have. Or if you know a place to...

PM sent

Welcome to the forum

Wow, great trophy, and so lucky to get one at such a young age. The state must of done a pretty good job of introducing and managing that small herd. All the boys in Western Nebraska will be lining up to ask her if they can go hunting with her!

welcome from sunny Arizona. enjoy the forum.

That’s a beautiful gun. Welcome aboard!

Greetings and welcome to the forum. Glad you joined.

Well I found them on Ruger.com. Size 6/40. They sell an upgraded version with Hex heads for $6.95 for 8 screws. I should have known to look there first.

Does anyone know the the size / thread of the screws that go into Ruger scope rings? Are they all he same? Where can replacement screws be purchased? Just need a few. Thanks

WOW, So sad to hear this news. Mike was so active in the Ruger Community and a true leader. His passing will leave a big void. Prayers for this family.

.243 has always performed for me. Shot placement is very important but I think bullet selection is most critical. I only use hand loaded 100gr. Hornady or my go with my favorite the Nosler Partition for everything. I think this caliber, properly loadEd with the right bullet will take anything...

Welcome to the Forum.

Welcome to the best Ruger Forum.

Welcome