FentyFloyd
Bearcat
Re assembling the gun, the trigger guard and all attached parts are having lots of trouble going back in. I'm making sure the transfer bar is free and clear and it does not bind. I can't get this thing in.
In the event that it finally snaps in, the trigger is completely stuck and will not move. I remove the trigger guard and start this whole process all over again.
Eventually, I purposely left out the transfer bar and pawl and corresponding plunger and springs and it goes in perfectly, the trigger pulls. I put the pawl and transfer bar back in and removed the cylinder stop, and it also allows the trigger to pull. So I assume there is some combination of these parts that are causing the trigger to bind.
Any ideas?
In the event that it finally snaps in, the trigger is completely stuck and will not move. I remove the trigger guard and start this whole process all over again.
Eventually, I purposely left out the transfer bar and pawl and corresponding plunger and springs and it goes in perfectly, the trigger pulls. I put the pawl and transfer bar back in and removed the cylinder stop, and it also allows the trigger to pull. So I assume there is some combination of these parts that are causing the trigger to bind.
Any ideas?
Last edited: