MG-70
Single-Sixer
Bought a used Hogue Monogrip for the 9mm SP101 and when it came in, the hole for the grip locator pin was much smaller than the pin that came on my gun. I'm planning on making a pin out of some aluminum rod or something and was wondering if anyone knew the correct diameter of the thinner grip pin? I've already emailed Hogue and IIRC Ruger, but haven't heard from them. I figure since there will be downward pressure on the pin, there may be no real need for a thicker sleeve to fill the void in the grip tenon...don't know.
Thanks in advance!
Thanks in advance!