gasmandave
Single-Sixer
Just bought a Carryhawk. Went to take the yellow disc out and had a difficult time getting the cylinder pin out. Finally after jiggling it it came out but with great difficulty. Then the loading gate would not open. After fiddling with it it opened. Rolled the cylinder out remove the yellow disc and put the cylinder back in. Now the pin would only go in about a third of the way. Again, fiddling and jiggling it went in almost all the way but lacked about a sixteenth of on inch to lock and that was it. Now it won't move either in or out, the loading gate won't open and hammer won't cock or cylinder turn.
Needless to say it's enroute back to Ruger.
I was very shocked with the problem out of a new revolver from Ruger. Hope they get it fixed and returned quickly.
Anyone have any similar circumstances?
Maybe it was a knock off from China.
Needless to say it's enroute back to Ruger.
I was very shocked with the problem out of a new revolver from Ruger. Hope they get it fixed and returned quickly.
Anyone have any similar circumstances?
Maybe it was a knock off from China.