45flattop
Single-Sixer
As in the pin radius on the beavertail? Does the radius on the one Ruger
puts on the SR1911 match other maker's profile so that another maker's
beavertail could be a drop in install? The one on my SR1911 Commander
seems to be somewhat narrower than ones on other of my 1911s from
Baer, Ed Brown, etc. I would prefer one a tad wider left to right than
the Ruger factory issue model but if the geometry on the Ruger ones
is significantly different from others, I have a problem. I also have
a concern on the loop or Commander profile hammer and it also
working with a hypothetically different beavertail
Any assistance will be greatly appreciated...…….thanks.
puts on the SR1911 match other maker's profile so that another maker's
beavertail could be a drop in install? The one on my SR1911 Commander
seems to be somewhat narrower than ones on other of my 1911s from
Baer, Ed Brown, etc. I would prefer one a tad wider left to right than
the Ruger factory issue model but if the geometry on the Ruger ones
is significantly different from others, I have a problem. I also have
a concern on the loop or Commander profile hammer and it also
working with a hypothetically different beavertail
Any assistance will be greatly appreciated...…….thanks.