RugerForum.com

This is the H&G truncated cone bullet I plan to shoot in a SR1911 -
http://www.accuratemolds.com/bullet_det ... 200H-D.png

Any known issues with Ruger stock or Checkmate magazines?

_________________
Regards
John

I found the H&G 68, which is a lead semi-wadcutter, works okay in the issue magazines. I had serious double-feed problems with commonly-available hard-cast 230 gr RN, but I don't recall the mold number. Even though I've standardized on the LSWC, I lost confidence in the stock magazines (sold on eBay) and rely exclusively on Wilson 47Ds. More than 10K rounds later, I've had no problems with this bullet/magazine combination.

I'm not using that exact bullet, I'm using the 225 grain TCFP from Missouri Bullet, just loaded some up the other day and shot them today with no problems. They aren't quite as accurate as the 200 grain RNFP I had been using but they will work fine for my uses.

_________________
Buy American, it may be your own job you are saving!