Ruger OM .45 Blackhawk - what would you do?

David Clements does great work on Rugers.

http://www.clementscustomguns.com/

Depending on where you live in the Tarheel State, you may want to drive to Southwest Virginia and deliver it yourself. His shop is about 25 miles north of Mount Airy NC.

David Clements does great work on Rugers.

http://www.clementscustomguns.com/

Depending on where you live in the Tarheel State, you may want to drive to Southwest Virginia and deliver it yourself. His shop is about 25 miles north of Mount Airy NC.

I bet DougGuy could help. He works on cylinders all the time. He's a member here. Fast turn around time too. Tarheel too!

But,, any good machinist who can square up a cylinder in the mill can hone off the few thousands easily too.

Muley Gil said:

David Clements does great work on Rugers.

http://www.clementscustomguns.com/

Depending on where you live in the Tarheel State, you may want to drive to Southwest Virginia and deliver it yourself. His shop is about 25 miles north of Mount Airy NC.

Click to expand...

He is less than two hours from me. Didn't want to wait for his typical turnaround times, but maybe he could do this one relatively quickly. Haven't been up to see him in a while, so maybe this is a good excuse.

I'll check in with DougGuy as well. Thank you both!