RugerForum.com
http://www.rugerforum.com/phpBB3/

Blackhawk/GP100 rear sight question
http://www.rugerforum.com/phpBB3/viewtopic.php?f=3&t=283477
Page 1 of 1

Author:  Trailduster [ Sun Dec 08, 2019 2:11 pm ]
Post subject:  Blackhawk/GP100 rear sight question

Quick question for the more
knowledgeable folks.

Will Ruger NM Blackhawk rear
sight assembly interchange with
GP100 .357?

Thanks
Doug

Author:  RoninPA [ Sun Dec 08, 2019 5:03 pm ]
Post subject:  Re: Blackhawk/GP100 rear sight question

No they are not interchangeable as far as I can ascertain.

You can compare parts by using: https://www.gunpartscorp.com/ and using the different firearms schematics. The part numbers for the sights for the NM Blackhawk are different from those for the GP100.

You could also go on the Ruger site to compare parts.

Author:  jpickar [ Tue Dec 10, 2019 8:50 pm ]
Post subject:  Re: Blackhawk/GP100 rear sight question

I just looked at my BH, SBH, SS and GP100. Without taking them out and trying them for 100% I don't see why they wouldn't be interchangable.

Author:  98Redline [ Wed Dec 11, 2019 6:42 am ]
Post subject:  Re: Blackhawk/GP100 rear sight question

I am pretty sure the sights are interchangeable.

If you look on Bowen’s site, the replacement sight for any of the Ruger single or double action guns with the “ears” are the same

Author:  RoninPA [ Wed Dec 11, 2019 8:56 am ]
Post subject:  Re: Blackhawk/GP100 rear sight question

That is very possible, I was going by the part numbers used by Numrich and they were different. It may be that Ruger numbers them differently for each revolver even though they are the same. For the best/exact answer would be to call Ruger to see what they say.

Author:  s4s4u [ Thu Dec 12, 2019 9:03 pm ]
Post subject:  Re: Blackhawk/GP100 rear sight question

I am fairly certain that Ruger uses the same sight base in all models, but there may be a different blade in some which may account for a different part number. Bill was all about keeping costs down.

Author:  protoolman [ Fri Dec 20, 2019 9:41 pm ]
Post subject:  Re: Blackhawk/GP100 rear sight question

I think the width of the blades and white outline or not is the only difference. Base is the same?

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/