SP101 hammer pin

Thumbcocker · Mar 27, 2019

My SP101 hammer pin tends to back out a bit when shooting or dry firing. The grips prevent it from getting to far but it stands a bit proud on the right side of the frame. I would like for it to fit a bit tighter. Any home gunsmith suggestions?

Jimbo357mag · Mar 28, 2019

I would be temped to put a tiny drop of c/a (super glue) under the flat of the pin to keep it flush. An easy tap from the other side would break it loose when needed.

rugerfreak · Mar 31, 2019

Mine would spin around and back out when dry firing----sent it back to Ruger and now its good.

Varminterror · Apr 6, 2019

Throw a drop of epoxy on the underside of the grip where the hammer pin tab sets. Effectively create a pressure pad against the tab.

SP101 hammer pin

Help Support Ruger Forum:

Thumbcocker

Blackhawk

Jimbo357mag

Hawkeye

rugerfreak

Single-Sixer

Varminterror

Blackhawk

Similar threads

Latest posts