Jun 23, 2017 #1 1 10mm Single-Sixer Joined Mar 4, 2004 Messages 176 Location Republic of Texas Anyone ever experimented with cutting a Blackhawk 30 carbine barrel down to say 5.5 inches?
Jun 23, 2017 #2 veeman Single-Sixer Joined Feb 12, 2015 Messages 455 Location Illinois Nope. Loud enough as is at 7 1/2".
Jun 23, 2017 #3 Lngstrt Single-Sixer Joined Dec 6, 2015 Messages 119 Location Phoenix ... Land of the Blazing Sun!! veeman said: Nope. Loud enough as is at 7 1/2". Click to expand... And a fairly impressive ball of flame as I recall. :shock:
veeman said: Nope. Loud enough as is at 7 1/2". Click to expand... And a fairly impressive ball of flame as I recall. :shock:
Jun 23, 2017 #4 H Hondo44 Hawkeye Joined Apr 3, 2009 Messages 8,051 Location People's Republik of California A few cut back to 4 5/8" have been discussed on this and other forums. Owners had no complaints after cutting them.
A few cut back to 4 5/8" have been discussed on this and other forums. Owners had no complaints after cutting them.
Jun 23, 2017 #5 Snake45 Hawkeye Joined Mar 14, 2009 Messages 9,205 Location +4020 Why not cut it to 3" and deafen the whole neighborhood? :lol:
Jun 23, 2017 #6 Jimbo357mag Hawkeye Joined Feb 22, 2007 Messages 10,350 Location So. Florida Being a revolver you can load the cartridge in a way that suits the shorter barrel. Factory ammo is high pressure.
Being a revolver you can load the cartridge in a way that suits the shorter barrel. Factory ammo is high pressure.
Jun 23, 2017 #7 veeman Single-Sixer Joined Feb 12, 2015 Messages 455 Location Illinois I use 32-30 brass in mine with 32-30 and 32 mag loads.