Nov 15, 2014 #1 Joe S. Hunter Joined Feb 4, 2011 Messages 4,805 Location Central MS Got my Single Seven back and this was listed under the work done to it. What is this?
Nov 15, 2014 #2 bcgunworks Single-Sixer Joined Sep 11, 2014 Messages 206 Location Mathews va I wonder if they mean crown?
Nov 15, 2014 #3 protoolman Service-Sixer Joined Oct 15, 2001 Messages 2,577 Location MN and MT Or recut the forcing cone.
Nov 15, 2014 #4 M mohavesam Hawkeye Joined Jan 4, 2004 Messages 5,847 Location Rugerville, AZ back from where?
Nov 16, 2014 #5 Joe S. Hunter Joined Feb 4, 2011 Messages 4,805 Location Central MS Sent it to Ruger for a base pin issue.
Nov 16, 2014 #6 H Hondo44 Hawkeye Joined Apr 3, 2009 Messages 8,051 Location People's Republik of California Hi Joe, A barrel can only be chamfered at the muzzle or at the throat. So apparently one or both had a very sharp lip either on the outside diameter or bore. Can you see any shiny edges at those locations where some chamfering was done?
Hi Joe, A barrel can only be chamfered at the muzzle or at the throat. So apparently one or both had a very sharp lip either on the outside diameter or bore. Can you see any shiny edges at those locations where some chamfering was done?
Nov 16, 2014 #7 Joe S. Hunter Joined Feb 4, 2011 Messages 4,805 Location Central MS Jim It isnt obvious at either end...
Nov 17, 2014 #8 H Hondo44 Hawkeye Joined Apr 3, 2009 Messages 8,051 Location People's Republik of California If there's a chamfer now, it may just have not had any before.