stevenliong
Bearcat
- Joined
- Jul 17, 2010
- Messages
- 3
The most common complaint about the takedown pin of the SR9c is that "it's too hard to remove". This was my case at first, but after a while it actually loosened up to the point where it is currently "too loose". It won't fall out or anything (as tends to happen frequently with the cam block pins), but I bet it shouldn't feel as loose as it actually feels at the moment. Every time I rack the slide I notice the take down pin move a bit outward (to the left). So my question is, how can I make the take down pin fit better or make it "move less"????