the manual states with the allen screw loosened drift the sight using a wooden dowel in either direction - my problem after using oak dowels which i had to keep cutting off to square the end i did not move the sight so i had to use a brass drift to slightly move the sight.
any idea why this is happening - maybe i will just pound to out and either replace or file it to fit if any thing is left - i know beating it to death is not correct but options that i can think of are zero
any idea why this is happening - maybe i will just pound to out and either replace or file it to fit if any thing is left - i know beating it to death is not correct but options that i can think of are zero