Sr9c help.

Hey all, new to the forum but not to firearms. I was hoping somone could help me out. I cleaned my src after shooting a couple hundred rounds earlier an when i was trying to reassemble it i couldnt get the slide assembly back on. Ive had this gun dissassembled numerous times and have never had this problem. The slide stops at where it would be when at a normal position, it will not go far enough back to install the pin. Any suggestions? Thanks, Donnie

Make sure the ejector lever is pushed down and the trigger is fully forward - see your manual.

GunnyGene said:

Make sure the ejector lever is pushed down and the trigger is fully forward - see your manual.

Click to expand...

+1 I expect the ejector lever popped back up while you had it apart. Push it back down.