1022Good
Bearcat
A nice add for back pocket carry, just in case. Makes it so that your LCP is camouflaged to look like your wallet if it ever becomes visible in your pocket.
I've carried mine this way in an Uncle George's pocket holster for years and the set up works very well for me. In most of my jeans, the back pocket is deep enough so it's invisible and it looks just like a wallet, but in a couple of pairs jeans a partial view of the goods could be exposed ever so slightly if you are looking down at the right angle from above. Check out the pictures below. I added this originally about two years ago. I fully expected it to be temporary as I thought it would wear off in time, but it hasn't. Here's how I did it. I printed the fat wallet on a color printer on regular paper, trimmed it and made a few small cuts to allow it to conform to the shape of the back strap, and used scotch tape to put it on my gun. I've shot this gun many times since and it's still hanging there. It's nothing expensive, but for a gun dedicated to concealed carry, it's a nice bit of added concealment. At this point, I don't think I'll have to do it again any time soon unless they make the LCPs Pro! Feel free to use the fat wallet lcp.jpg below.
Back Pocket View (keep in mind this picture is taken with the flash on)
Gun and Holster (notice small cuts in the paper for the bends of the back strap)
Gun only (notice small cuts in the paper for the bends of the back strap)
Here is a picture you can use, just save and print (fat wallet lcp.jpg):
I've carried mine this way in an Uncle George's pocket holster for years and the set up works very well for me. In most of my jeans, the back pocket is deep enough so it's invisible and it looks just like a wallet, but in a couple of pairs jeans a partial view of the goods could be exposed ever so slightly if you are looking down at the right angle from above. Check out the pictures below. I added this originally about two years ago. I fully expected it to be temporary as I thought it would wear off in time, but it hasn't. Here's how I did it. I printed the fat wallet on a color printer on regular paper, trimmed it and made a few small cuts to allow it to conform to the shape of the back strap, and used scotch tape to put it on my gun. I've shot this gun many times since and it's still hanging there. It's nothing expensive, but for a gun dedicated to concealed carry, it's a nice bit of added concealment. At this point, I don't think I'll have to do it again any time soon unless they make the LCPs Pro! Feel free to use the fat wallet lcp.jpg below.
Back Pocket View (keep in mind this picture is taken with the flash on)
Gun and Holster (notice small cuts in the paper for the bends of the back strap)
Gun only (notice small cuts in the paper for the bends of the back strap)
Here is a picture you can use, just save and print (fat wallet lcp.jpg):