last Saturday my wife gave me 2 hours early morning to run to the county gun show. I liked the sr40c so picked one up.. i didnt inspect it as well as i should have. Its "new".. doesnt appear to have had anything but its test factory round through it.. but on the chamber end of the barrel where the slide interacts with the barrel.. there is peening on the upper outer edge of the barrel with a nice spur. The barrel and slide fit together in a unique fashion.. when the slide comes forward it fits the barrel like a puzzle piece and the tilted barrel comes up.. but the barrel has a tiny wiggle to it.. and this motion.. when the slide comes forward.. before the barrel lifts.. it HITS and peens.. even being a new pistol i have not shot yet and had only racked the slide on a handful of times. Anyone experience this? is this gun worth my time money and effort? Can Ruger ACTUALLY fix this or is it design flaw.. trying to decide if i should just eat my losses and trade it out for something else??.. A bit unsure and pissed off to say the least