BullseyeX10
Bearcat
- Joined
- Feb 15, 2014
- Messages
- 3
Hey everyone,
I have a LC9, with a completely stock, factory trigger. No Galloway parts, etc. Only thing I've done to the gun was to disable the magazine safety. After about 150 rounds through the gun, I started noticing the trigger isn't resetting.
The gun fires, the slide cycles, and extracts and ejects normally. But when I try to fire another round, I have to pull the trigger back the whole way and let go in order for the trigger to reset.
I fire a round, then when pulling the trigger for the next shot, the trigger just goes "to the floor". When I pull it back there is absolutely no resistance or spring pressure. Once I release the trigger again it will then fire normally. This happens EVERY time.
I have the gun completely disassembled and have found nothing obvious, ie: no broken or bent parts, etc.
Any ideas on what the problem and the solution may be? I would like to handle this issue myself and not have to send it off to Ruger.
Thanks!
I have a LC9, with a completely stock, factory trigger. No Galloway parts, etc. Only thing I've done to the gun was to disable the magazine safety. After about 150 rounds through the gun, I started noticing the trigger isn't resetting.
The gun fires, the slide cycles, and extracts and ejects normally. But when I try to fire another round, I have to pull the trigger back the whole way and let go in order for the trigger to reset.
I fire a round, then when pulling the trigger for the next shot, the trigger just goes "to the floor". When I pull it back there is absolutely no resistance or spring pressure. Once I release the trigger again it will then fire normally. This happens EVERY time.
I have the gun completely disassembled and have found nothing obvious, ie: no broken or bent parts, etc.
Any ideas on what the problem and the solution may be? I would like to handle this issue myself and not have to send it off to Ruger.
Thanks!