Hammer Swap

I would like to swap in a stainless super blackhawk hammer in a new model stainless 357 mag blackhawk. Will it fit and any other new parts needed? Best place to buy a new super blackhawk hammer? Thank you all who respond.

Should be a drop in change.

There have been some dimensional changes to the profile of the "ears" at the top of the grip frame and the tapered "shelf" that surrounds the cylinder frame's "hammer well" over the years. This suggests that "same vintage" parts be mated to prevent some extra work. Fortunately you've stainless guns so no "refinishing" work will be required.

Case in point:



Early '90's stainless .45 Blackhawk being fitted with a Super Blackhawk Hunter grip frame. Note the mismatch and that it's the Cylinder Frame that needs the fitting and not the grip frame!



A bit of "elbow grease" can get 'er done, though.

The hammers have been profiled to fit the "ears" so you may need some fitting. I certainly don't want to discourage you since thousands of folks have added Super hammers to their Blackhawks. Being educated that there may be some difficulties is always a good thing.

JMHO,

flatgate

I've gotten all my SBH hammers thru "Gun Parts" online.

I got mine from Midway . I reshaped mine to look like the stock one and make it easier to slip hammer it .

http://www.rugerforum.com/phpBB/viewtopic.php?t=61126


just did mine