The rear receiver screw was cross threaded and or seized. Head stripped and then bolt broke off. I have drilled it but there is still some of the screw in there. I was hoping to retap but not sure on thread size or if I have a good tap. Am I going about this the right way? Learning the hard way and looking for input.
I was lucky to find a couple loose parts inside the gun but still need an "E" clip to make it whole. May just leave it off for now as the stock holds the pins in anyway.
Thanks,
I was lucky to find a couple loose parts inside the gun but still need an "E" clip to make it whole. May just leave it off for now as the stock holds the pins in anyway.
Thanks,