Field Testers Needed - Ruger American Rifle Shims

Hi Guys,
I need a couple Shim Kit Field Testers, I have done this before here on RugerForum.com with great success.

I have a New Shim for the Ruger American Rifle.

I think the overall feel and trigger pull of most firearms can be improved
somewhat with shims, and I think the Ruger American Rifle falls in that category.
I made this same type of shim pak a year or two back for the Savage Accu-Trigger / Axis / Edge
and they worked well, so it was time for the R.A.R.
But, I don't have one to try out...... so....

Here's the deal...... The first 5 guys who have a Ruger American Rifle, and reply to this topic,
I will send an 8 Pak set of Shims to fit this rifle..... but....
The FINE PRINT......
You will be asked to install and report back within a week to 10 days from receiving the shims.
If You don't think you will have time to install them, please don't volunteer.
I will want to know how well they fit the Trigger and Sear pins, and if the assortment of thicknesses you received was about what was needed for a successful installation.
Also, if you can send some photo's, that too would be great.
I will need your name and address, you can send me a PM, or better yet, email me at [email protected] but reply to this thread first, to claim your place,
I will only be sending out 5 free sets, when they are gone, they are gone.....
but..... previous TriggerShims.com Field Testers will be given special consideration.

And as always, Thanks to FlatGate for allowing me to post here,
the Rugerforum.com is the best, and I highly recommend it to folks as a friendly place to go
for good information and camaraderie!

God Bless and
Good Shooting,
Lance (L.C.) Shively
TriggerShims.com

A bump for Lance. Must not be many who work on them if they have them.
Good luck friend.

Hi Guys,

Offer is closed on this, I have a couple models of American Rifle coming into the shop
for this project, in Rimfire and .450 Bushmaster.

Shims should be ready in January 2018

Good Shooting,
Lance