Ejector Rod Replacement

Pete · Oct 30, 2014

I have a Ruger Blackhawk .357,1966 dated with a 4 5/8 inch barrel that is a great shooter.I do not like the very small button on the ejector rod and was wondering if there is an inexpensive way to remedy this?

rugerguy · Oct 30, 2014

by 1966 that should be about the largest one that Ruger offered, best bet would be an aftermarket, 'crescent' shaped one from someone like Brownells............

Pete · Oct 30, 2014

Thank you! I am aware of the aftermarket ones,I was just hoping there would be something a little less expensive and easy to get somewhere else.I guess I will just use what I have for the time being.

medicdave · Oct 30, 2014

Look for used ones on the auction sites. This ones a virginian dragoon, but just about anything can be modded to work. Think the last dragoon one I got was $7.

Pete · Oct 31, 2014

Now that looks like it will work and is in my expense area-Thanks !!

medicdave · Oct 31, 2014

Little tough to find the dragoons, but any of the colt replicas will work as well. Ruger has the ejector rods of the new vaqueros as well if they float your boat. $15 iirc.

Pete · Oct 31, 2014

Is that $15 from Ruger and is the part available from them?That may be a little smaller than I was looking for but it may just work!

medicdave · Oct 31, 2014

Yup from Ruger or Brownells I was mistaken had to go back and look $8 for blue and $9 stainless from Brownells.

New vaquero ejector rod assembly

Blue: MVQ10800
Stainless: KMVQ10800

Pete · Oct 31, 2014

Thank you !! I need the blue.

Ejector Rod Replacement

Help Support Ruger Forum:

Pete

Single-Sixer

rugerguy

Hawkeye

Pete

Single-Sixer

medicdave

Blackhawk

Pete

Single-Sixer

medicdave

Blackhawk

Pete

Single-Sixer

medicdave

Blackhawk

Pete

Single-Sixer

Similar threads

Latest posts