Recent content by SlickRS23

Sent you a message

Hi Mark, sent you a PM

Sent you a message Jeff

Hello, I have some I can sell you. I sent a message. Jeff

Relied to PM's

For sale, Ruger Blackhawk in 357 Maximum 7.5" barrel w/ Box and manual. I am experiencing an issue with bullet jacket between barrel and cylinder. Here is a post regarding this issue: http://www.rugerforum.com/phpBB3/viewtopic.php?f=12&t=114109 I never got around to looking further into...

Here's a pic of mine Seems like Ruger used to make the grips oversize and roll the edges. Now they're making them slightly under size. I think they're avoiding fitting grips as part of manufacturing. They don't feel bad like this. Just looks kind of different What does the P mean?? Plywood??

http://www.rugerforum.com/phpBB3/viewtopic.php?f=6&t=257992 Well, I finally tested my new toy as mentioned in the above post. Gun shot very well, a lot more accurate then me. As I shot it the base pin would slide forward after every shot. And this is with my mild loads. Then I noticed that the...

Loading up some ammo for my new toy. I like using dippers when ever possible, as I can get very consistant with them when using Unique. Seating the bullets, then crimping next. Now I'm ready to test it out with my favorite 45 Colt cowboy loads. Think I'm gonna try fitting a "Hunter" grip...

Hello, I have been sending E-mails to you since Saturday July 15 with a question on payment thru paypal. Should I use your E-mail address to send payment?? Thank You, Jeff

A couple of 45 Colts I've been bringing to the range a lot lately.

Very, very nice! I found a lot of good advice and suggestions in this post.

I try and stay away from Winchester brass as I have a hard time getting the primers seated without flattening them. All other brands the primers seat very well, it's the Winchesters that seem to have very tight primer pockets. I found this problem not only with the 44 Mag., but also 44 Spec...

I'll take 100, 44 Special Sent you a PM

Hello, I have been using one of them ultrasonic cleaners for a while now with a drop of dish soap and have had pretty good results. They get clean, but not shiny. Recently I have been trying to get better results, so I purchased some RCBS case cleaning solution, which works better. I noticed the...