Recent content by Shiftless

I have an Alien Gear that I purchased the 9e and M&P shells for. I now have the M&P 45 shell on at the moment, but.... the 9E and the American 45 BOTH fit snugly into the M&P shell and I wouldn't have a problem carrying either one in that shell. I traded the M&P 45 for the American 45 a couple...

https://gallowayprecision.com/ruger/sr/optic-mount-for-ruger-sr9-sr9c-sr40-sr40c-sr45/ https://gallowayprecision.com/ruger/optic-mount-plate-for-ruger-sr9-sr9c-sr9e-sr40-sr40c-sr45-pistols/ There are a few others as well. Good luck!

Little long winded I guess :wink: Just condensed a few months hard research into a small paragraph. It must be the IT tech in me, also taught as a professor at a tech school a few years and a telecommunicatioms tech over 30 years (read that as Geezer!). Point is, I deal with hard real data...

The pistol bullet combination that allows for full/maximum expansion within the body cavity. Having said that, the 9MM and 45 are the most common and available, cheapest to shoot. 9mm HST 124 gr hollow point or 45 230 gr HST or similar round.... around 14" is the deepest penetration you need...

Since the serial number is on the inside on the sub assembly and not the frame, it seems reasonable there will be a future system for caliber mods? That would be pretty cool, maybe an American .40 swap out is on the horizon for us/me... A drop in assembly to change a 9mm to a 40 or 45 would...

I too was pleasantly surprised by the 9e, some folks would call it a sleeper. I shoot it well, must be the pistol? I also had just acquired a new S&W M&P45 in May, nice weapon, but I traded it yesterday on a new American 45, I just didn't like the trigger..... the cut of its' jib I guess. Very...