Recent content by Rosie65

Both are DC. The difference is the pivot point on the barrel and how the spring guide is made on the back end. Yeah I know those are the wrong names for them but I think you understand. BTW I ran over it with my riding mower after it fell out of my holster. :oops: :oops: I was lucky it only...

Yes I can. They don't eat anything! :lol:

I have a bucket, 1950 rounds, of Remington golden hollow points that was bought in the last three weeks. Considering what others are getting for them I would say about 12 cents a round. I will check some other sites and get back with you if the price is higher or lower. The bucket was 1400...

I broke the frame on my P89 and a friend has one but my slide and barrel won't fit on his. Was a change made at some point by Ruger?

Broke mine and have all the parts except the frame.

Need a 10/22 rifle and or a Ruger MK111, 3? 45 for my grand son. Will trade 22 shells as partial payment. I have lots of them! Remington and Federal. Northeast Indiana.

Can someone tell me the difference between these pistols? I have shot the P89 but never saw a P85. Never liked the Ruger pistols until I shot the P89. Dang thing is loose as a goose but it sure would hold up it's end!

Thanks guys. That sticky did the trick.

Can someone tell me how to change the firing pin on a P89DC? I know how to field strip but thats about it. Thanks in advance.

Ruger said if the gun had been shipped as a 357/9mm they would do it but will NOT install a 9mm cylinder gun that was shipped as a 357 only. May still give it a try. Have to think about it for a while.

What about alignment and barrel ID?

Thanks to all who replied but I called Ruger and they said a cylinder would have to be fitted and they won't do it because the gun left the factory as a 357 only. I think I will give up on that idea. I have a couple of thousand round of steel case ammo and was looking for a cheap way of shooting...

9mm cylinder for a Ruger new model Blackhawk. Don't have to be in great shape. A little rust on the outside won't hurt. In other words, Cheap!! :lol:

Guess that will teach me not to go away when I'm wanting to buy something!! :lol:

My cell number is, 260-242-0517 or if you want I will call you. Just send me your number. My new model is within .004 over all of your measurements but I need to know what the cylinder body is. Mine is 1.638. If yours measure the same send me your address and I will send you a money order. Rosie